Sitemap
All pages at a glance
Browse every page on lichtvision-engineering.com.
News articles
- eFIXX: DALI fittings not responding? Addressing problem
- eFIXX explains ProbitSite's expert mode
- Release ProbitSite firmware 1.5
- Nortronic, Elektrokovina, ZETAQLAB & Kitoko are new distributors
- ProbitSite goes Japan, Singapore, Australia and New Zealand
- IEC 1906 Award for our CEO Karsten Heinrich
- Lichtvision Engineering at Light + Building 2024
- ProbitSite in the media
Tutorials
Changelogs
DALI Knowledge Base
- Why does my DALI tester show a 'bus traffic' error and refuse to scan, and can I test the line without disconnecting the gateway?
- How do I make individual DALI luminaires blink to identify them?
- I installed all my DALI devices but nothing happens, how do I get control of my lights?
- I measure a DALI voltage but communication is unreliable, how do I fix it?
- Not all my DALI devices are found during commissioning, but broadcast commands work, why?
- My DALI signal quality is poor (yellow or red), what are the causes and how do I fix it?
- Why do I have duplicate DALI short addresses, and how do I fix them?
- Why do my automated DALI emergency lighting tests fail with 'duration test max. delay exceeded' when manual tests pass?
- Why do my DALI luminaires work individually but drop off the bus or become unreachable when adding more devices to the line?
- What is the difference between 'DALI Compliant' and 'DALI-2 Certified', and can non-certified gear cause random flickering?
- Why does my DALI gateway report finding 64 devices during a scan when fewer luminaires are actually installed?
- How can I replace a luminaire in a DALI installation without a PC to assign the correct address?